Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!ucsd!tut.cis.ohio-state.edu!cs.utexas.edu!csd4.milw.wisc.edu!leah!rpi!rpi.edu!hiebeler
From: hiebeler@cardinal.lanl.gov (David Hiebeler)
Newsgroups: comp.graphics
Subject: C library for VT100/Retrographics?
Message-ID: <HIEBELER.89Jun22215512@cardinal.lanl.gov>
Date: 23 Jun 89 01:55:12 GMT
Sender: usenet@rpi.edu
Distribution: comp
Organization: Center for Nonlinear Studies, LANL
Lines: 17


  Hi there.. I recently aquired a VT100 with a Retrographics board
in it.  (Apparently this is tektronix compatible to some degree (?)).

  Anyways, I was thinking of writing a small set of C routines to
do simple graphics on this thing (such as vector(x0,y0,x1,y1)), which
would echo the proper escape-sequence to draw on the terminal.
  Before I go and do this, has someone already done it?
  Please reply via e-mail, I don't know how long I'll be following
this newsgroup..
  Much thanks in advance,

--
Dave Hiebeler                       hiebeler@cardinal.lanl.gov
Center for Nonlinear Studies        hiebeler@cs.rpi.edu
MS B258
Los Alamos National Laboratory / Los Alamos, NM 87545