Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!rochester!udel!mmdf From: akeef@asd.wpafb.af.mil (Earle Ake) Newsgroups: comp.sys.amiga Subject: Re: Homebrew Cables Message-ID: <17994@louie.udel.EDU> Date: 19 Jun 89 15:27:34 GMT Sender: mmdf@udel.EDU Lines: 47 Alan, I don't know how far you could extend your AMIGA external drive cable without degradation. If it goes by the standards of RS232C, you could get away with 50 feet or so! I believe it would be safe to assume that a distance of 10 or 15 feet would be reasonable if you needed that much. As far as DB23 connectors go, I may be able to help. In Dayton, Ohio we have an annual event called HamVention where a lot of HAM radio operators meet and have a large swap meet. They also enjoy computers as well. There were 3 dealers set up this year that had DB23 connectors. Here are the addresses and phone numbers of the three. I don't work for any of them, I am just providing information. CNE 305 University Blvd Glassboro, NewJersey 08028 (609) 881-6779 "D" Connectors 23 Pin Female .65/each .575/each quantity ten or more 23 Pin Male .75/each .625/each quantity ten or more "D" Connectors with hood DB23 Female 3.50/each DB23 Male 3.00/each LTRON 8245 Brookside Rd. Elkins Park, PA 19117 (215) 671-1613 (215) 924-4000 Prices about the same as "CNE" Bill Barrick 13 Lafayette Drive Phoenixville, PA 19460 (215) 933-0369 Again prices about the same as "CNE" I know the prices for "CNE" only because I have their catalog. Hope this helps you and anyone else out that needs DB23 connectors for their AMIGA. -Earle Ake akeef@asd.wpafb.af.mil