Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!cs.utexas.edu!csd4.milw.wisc.edu!dogie.macc.wisc.edu!indri!uflorida!beach.cis.ufl.edu!khawkes
From: khawkes@beach.cis.ufl.edu (Kurt Hawkes)
Newsgroups: comp.sys.amiga
Subject: Re: Dnet Script files
Summary: DNet and AREXX
Keywords: dnet
Message-ID: <20487@uflorida.cis.ufl.EDU>
Date: 20 Jun 89 03:55:48 GMT
References: <1452@ndmath.UUCP>
Sender: news@uflorida.cis.ufl.EDU
Reply-To: khawkes@beach.cis.ufl.edu (Kurt Hawkes)
Organization: UF CIS Department
Lines: 25

In article <1452@ndmath.UUCP> rsn@ndmath.UUCP (Ross Niebergall) writes:
>I would like to know if there is a way to execute a script file with dnet.
>What I want to do is startup dnet and then execute some file at the amiga
>end and it will log on to the unix end and perhaps run a program.
>
>I've tried to do this just bye echoing commands from the CLI to ser:, but
>dnet locks the serial device, and this is not possible.  If there is
>any way of doing this, I would appreciate the help.
>
>Thanks, rsn

I do not think you can use script files with dnet, but the idea of a  
AREXX port in dnet is not a bad idea.  With AREXX it would be possible
to do script files.  I purchased AREXX a little while ago and I am just
getting around to learning it.

Kurt Hawkes
khawkes@beach.cis.ufl.edu


--

--

Kurt Hawkes                         khawkes@beach.cis.ufl.edu