Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!bionet!apple!sun-barr!sun!imagen!atari!portal!cup.portal.com!Bob_BobR_Retelle
From: Bob_BobR_Retelle@cup.portal.com
Newsgroups: comp.sys.atari.8bit
Subject: Re: Asm/Ed cartridge quesion
Message-ID: <19799@cup.portal.com>
Date: 23 Jun 89 01:04:46 GMT
References: <8543@pyr.gatech.EDU>
Distribution: usa
Organization: The Portal System (TM)
Lines: 23

Mark Reed asked about the Atari ASM/ED cartridge SAVE command...
 
The SAVE command looks like this:  SAVE#D:FILE.EXT<STARTADDR,ENDADDR
 
The ADDR arguments are the HEX address for the start and end of the block
of memory you want to save to disk.
 
The cooresponding LOAD command is:  LOAD#D:FILE.EXT

The block will be reloaded into the same address space it was SAVEd to.
 
Note that this is ONLY for binary blocks of memory...
(finished OBJ code, data blocks, graphics images, etc..)
 
To save your SOURCE CODE to disk, use this command:
 
LIST#D:FILE.EXT  (optionally with  ,xx,yy   to save only lines xx to yy)
 
To reload SOURCE CODE, use:  ENTER#D:FILE.EXT
 
Note that all these commands must be done from the EDIT mode, not DEBUG.
 
BobR