Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!rutgers!mit-eddie!uw-beaver!tektronix!percival!bucket!leonard
From: leonard@bucket.UUCP (Leonard Erickson)
Newsgroups: comp.sys.tandy
Subject: Re: Model 4, DMP400 and 286/20
Message-ID: <1470@bucket.UUCP>
Date: 13 Jun 89 19:55:02 GMT
References: <1095@ucf-cs.UCF.EDU>
Reply-To: leonard@bucket.UUCP (Leonard Erickson)
Distribution: usa
Organization: Rick's Home Grown Unix; Portland, OR
Lines: 14

Well, all I had to do to hook my DMP-500 up to an XT clone was buy a
"standard" PC type printer cable and flip a couple of DIP switches in
the printer. The switches were in the CR=CR/LF position. I changed it
to CR=CR. (I already had LF=LF, but yours may have LF=CR/LF as a lot
of Tandy printers were setup that way)

As for graphics, if you get a copy of Tandy's MS-DOS, install LF.COM
and GRAPHICS.COM in the AUTOEXEC and you can dump graphics screens
to your printer.
-- 
Leonard Erickson		...!tektronix!reed!percival!bucket!leonard
CIS: [70465,203]
"I'm all in favor of keeping dangerous weapons out of the hands of fools.
Let's start with typewriters." -- Solomon Short