Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!AQUARIUM.ECN.PURDUE.EDU!moyman From: moyman@AQUARIUM.ECN.PURDUE.EDU (Mike "appletalk" MacMoya) Newsgroups: comp.protocols.appletalk Subject: Re: Problem with cap50 on Gould Powernode Message-ID: <8907051355.AA20602@aquarium.ecn.purdue.edu> Date: 5 Jul 89 13:55:38 GMT References: Sender: daemon@ucbvax.BERKELEY.EDU Organization: The Internet Lines: 29 --- Your mail of: Monday, 07/03/89 --- From: mcvax!ukc!icdoc!tgould!lmjm@uunet.uu.net (Lee McLoughlin) Subject: Problem with cap50 on Gould Powernode We've been trying, unsuccessfully, to get cap50 to run on a Gould Powernode which runs a 4.3 BSD version of Unix. The basic programs seem to work except that services never get registered. With atis running running atistest results in: Lee McLoughlin Department of Computing,Imperial College --- end of mail --- I have CAP 5.0 running on both of Gould's PowerNode 9080 (UTX 3.1u01 going thorugh a FastPath 1) and NP1 (UTX 2.0 going through a FastPath 2) arch's (both recieving 30-80 sessions daily)...The only *major* thing I remember doing is that you need to edit m4.setup to use SUNQUOTA instead of the standard BSD setup...It was a while back...I could not make out anything wrong from what you sent (other than it was not working)...Double checking the config type files might surface the problem. /etc/atalkatab, /etc/atalk.local, make sure you are using the *right* sockets for the kinetics box...etc.. Mike Moya Engineering Computer Network Purdue Universiy