Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!ukma!tut.cis.ohio-state.edu!osupyr!vkr From: vkr@osupyr.mps.ohio-state.edu (Vidhyanath K. Rao) Newsgroups: comp.sys.amiga Subject: Re: video problem in interlace Keywords: 1084 interlace problem Message-ID: <1305@osupyr.mps.ohio-state.edu> Date: 28 Jun 89 22:23:30 GMT References: <3104@csd4.milw.wisc.edu> <11989@s.ms.uky.edu> <292@cbnewsd.ATT.COM> <12009@s.ms.uky.edu> Reply-To: Vidhyanath K. Rao Organization: Dept of Math, Ohio St U at Newark, Newark, OH 43055 Lines: 26 In article <12009@s.ms.uky.edu> phoenix@ms.uky.edu (R'ykandar Korra'ti) writes: >In article <292@cbnewsd.ATT.COM> jmdavis@cbnewsd.ATT.COM (j.michael.davis,ix,) writes: >>I have this "interlace fuzzing" problem too. I notice it usually when I >>first power up. It doesn't happen often, but I have never seen it after >>my computer has been on for 8 hours or so. I usually (un)setlace and >>work for awhile that way then about 1 hour later I setlace and all is >>fine. > I wasn't going to post publicly on this (I Emailed the first person) >but since it seems to be a whole lot more common that I thought, I decided Actually, last summer saw a slew of postings on this subject and came to the same conclusions. My original suspision that this is temperature dependent is strengthened by the reappearance of this problem as the outside temp goes up. Another thing is that this problem will mysteriously clear itself up if you wait a bit. It should also be better on the latest versions of 1084 or the old 1080's [The first part is just a surmise. I haven't checked it. Would somebody try it and tell us?] I was away during last July and August. So I don't know if any solutions were found. If you have access to some archives, you may try searching thru them. I would dearly like a solution that costs <$50. -- It is the man, not the method, that Nath solves the problem. vkr@osupyr.mps.ohio-state.edu -Poincare. (614)-366-9341