Path: utzoo!attcan!uunet!ssbell!mcmi!amperif!unocss!mlewis From: mlewis@unocss.UUCP (Marcus S. Lewis) Newsgroups: comp.sys.zenith.z100 Subject: Re: null-modem software - Procomm clone for HZ100 now available Message-ID: <1017@unocss.UUCP> Date: 2 Jul 89 17:49:58 GMT References: <4231@kuhub.cc.ukans.edu> Organization: U. of Nebraska at Omaha Lines: 31 From article <4231@kuhub.cc.ukans.edu>, by RICHARD@kuhub.cc.ukans.edu (RICHARD KERSHENBAUM): > In article , w8sdz@WSMR-SIMTEL20.ARMY.MIL (Keith Petersen) writes: >> You may wish to try the ZCOMM106 program which I just uploaded to >> SIMTEL20. It's a Procomm clone for HZ100's. > ZCOMM is a nice program, but I desperately need something that will do VT-100 I just downloaded it yesterday and have a comment or three about it. I spent well over three hours on it before I managed to get it to dial my modem for me, including the 1170 code to disable call-waiting. It drops characters when scrolling. It doesn't respond to a Vax set term/inquire, and something happened to force not only a disconnect form the Vax, but also from the DecNet server. My personal opinion of this program is that is isn't worth the $35 registration fee as is. It isn't as good as Procomm, which I didn't like either, when I had to use it. And yes, it doesn't do VT-100, either ANSI or just plain terminal emulation. I tried several BBS's with it, and when selecting ANSI graphics, got the same garbage as when I try it with KERMIT. It needs work. Marc -- Na khuya mne podpis'? | Internet: cs057@zeus.unl.edu | UUCP: uunet!btni!unocss!mlewis Go for it! | Bitnet: CS057@UNOMA1 ---------------------------------------------------------------------------