Path: utzoo!attcan!uunet!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!agate!saturn!ucscb.UCSC.EDU!lcc
From: lcc@ucscb.UCSC.EDU (73701000)
Newsgroups: comp.unix.microport
Subject: Re: Driver Questions
Keywords: gfx mouse modules mkunix config PIC
Message-ID: <8248@saturn.ucsc.edu>
Date: 2 Jul 89 00:35:10 GMT
References: <219@rancho.UUCP>
Sender: usenet@saturn.ucsc.edu
Reply-To: lcc@ucscb.UCSC.EDU (Ken Chapin)
Distribution: na
Organization: University of California, Santa Cruz; CATS
Lines: 15

In article <219@rancho.UUCP> rock@rancho.UUCP (Rock Kent) writes:
>I'm running Microport's Sys V/386 ver 3.0e with DOSMERGE.
>
>In trying to get the gfx demo stuff to work, I noticed that the gfx
>module was commented out in system.std with an *.  When I tried to
>rebuild the kernel with gfx, I got the following:
>>  ld fatal: Symbol referencing errors. No output written to /etc/atconf/kernels/unix.std.18
>

The version of Merge that you have has got an old version of the console
driver in it that won't work with the gfx driver. You may be able to give
Peter a call at uport and get Merge 1.1.3. Mention that that you want to to
graphics with gfx and require the newer Merge.

Ken Chapin