Path: utzoo!attcan!uunet!cs.utexas.edu!csd4.milw.wisc.edu!uxc.cso.uiuc.edu!uxc.cso.uiuc.edu!ux1.cso.uiuc.edu!uxe.cso.uiuc.edu!jacobson
From: jacobson@uxe.cso.uiuc.edu
Newsgroups: comp.sys.amiga
Subject: Setting control panel in Amax
Message-ID: <45600068@uxe.cso.uiuc.edu>
Date: 15 Jul 89 03:44:00 GMT
Lines: 26
Nf-ID: #N:uxe.cso.uiuc.edu:45600068:000:1118
Nf-From: uxe.cso.uiuc.edu!jacobson    Jul 14 22:44:00 1989


About three weeks ago someone mentioned that they could not get the
changes in their control panel in Amax to save to disk and that after a
cold boot they were back to the original settings that were on the disk
when it was transfered from the Mac to Amax. I seem to remember a reply on
how one could get the changes you make to the control panel to save, but
at the time did not copy the info, and now I would like to know if I
am remembering right.

I have tried ejecting disks after I exit control panel both eject and 
drag the icon to the trash can, but this does not seem to save the info
either. Is there some trick I am missing. I did not notice the problem
because I had already had all my desktop parameters set before I transfered
my boot disk from my mac at work. Then a friend tried to make changes to
his and could not. I tried and found the changes did not survive a cold
boot.

Please send replies via email, Thanks in advance!

Russ Jacobson
Illinois Geological Survey

jacobson@uiucuxe
jacobson%uiucuxe@a.cs.uiuc.edu
jacobson%uiucuxe@uiuc.csnet
[ihnp4,pur-ee,convex]uiucdcs!uiucuxc!uiucuxe!jacobson