Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!cwjcc!gatech!ncsuvx!lll-winken!snll-arpagw!paolucci
From: paolucci@snll-arpagw.UUCP (Sam Paolucci)
Newsgroups: comp.sys.amiga
Subject: Re: Plplot on Aztec C
Message-ID: <129@snll-arpagw.UUCP>
Date: 17 Jul 89 01:39:25 GMT
References: <11285@cit-vax.Caltech.Edu>
Reply-To: paolucci@snll-arpagw.UUCP (Sam Paolucci)
Organization: Sandia National Labs, Livermore, CA
Lines: 32

In article <11285@cit-vax.Caltech.Edu> stevel@tybalt.caltech.edu (Steve Ludtke) writes:
->Hello. When Plplot first came out I was really interested in converting it
->to run under Aztec C. I worked on it a while and got everything except
->3d plots and contour plots to work. With a nasty litle workaround I could
->get 3d plots to work as well, but I had no luck with contour plots. At that
->point I got a message from someone who claimed to have it all working
->completely with a few changes he couldn't remember offhand. He said he'd post
->the modified sources to comp.sources.amiga within the next week or so. Well,
->this was several months ago, and he doesn't seem to respond to mail, so I'll
->ask this in general. Has anyone successfully ported plplot to aztec. If so,
->could you either post the mod. sources to the net or describe what you did ?
->Thanks

That person is me, and it was abot two months ago (I was on vacation
for about three weeks).  The reason for the delay is that I also added
a PostScript driver, and rewrote most of the Tektronix driver so that
the output is about four times higher resolution.  I also have a
makefile that will compile using either Manx or Lattice.  I promise
not to add anymore to it until I send it to Bob Page THIS WEEK.  I
don't know how long it will take after that to get posted.

->---------------------------------------------------------------------------
->Steve Ludtke
->stevel@tybalt.caltech.edu              ..!cit-vax!tybalt.caltech.edu!stevel



-- 
					-+= SAM =+-
"the best things in life are free"

				ARPA: paolucci@snll-arpagw.llnl.gov