Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!rutgers!tut.cis.ohio-state.edu!gem.mps.ohio-state.edu!ginosko!uunet!aecom!werner
From: werner@aecom.yu.edu (Craig Werner)
Newsgroups: comp.sys.ibm.pc
Subject: Re: Procomm not quite hangingup.
Keywords: procomm, hangup, annoying
Message-ID: <2346@aecom.yu.edu>
Date: 16 Jul 89 02:33:31 GMT
References: <8668@uhnix1.uh.edu>
Organization: Albert Einstein Coll. of Med., NY
Lines: 24

In article <8668@uhnix1.uh.edu>, cscc15@uhnix1.uh.edu (Keith A. Crabb) writes:
> I seem to have developed a problem with Procomm.  It will only
> hangup after doing a disconnect 2 or more times. While it will
> hangup, its very annoying to wait and have to check the phone
> to see if there is a dial tone present.  

	I spent about three hours last night trying to debug what might
quite possibly be the same thing. The solution was finally that the factory
settings of the modem didn't agree with other modems I had used, nor did
they agree with Xtalk or ProComm. (They did agree with MicroSoft Works,
although with some weirdness on Parity, but that's besides the point).

	Sending the following to set up the modem firmware

	AT&C1&D2&W

	seemed to make everything work OK. It changes the way the modem
reacts to carrier detect and DTR changes.  

-- 
	        Craig Werner   (future MD/PhD, 4.5 years down, 2.5 to go)
	     werner@aecom.YU.EDU -- Albert Einstein College of Medicine
              (1935-14E Eastchester Rd., Bronx NY 10461, 212-931-2517)
                           "Trust me. I'm almost a doctor."