Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!tandem.UUCP!leo
From: leo@tandem.UUCP (Leo Hejza)
Newsgroups: comp.laser-printers
Subject: Laserwriter memory upgrade.
Message-ID: <8907241433.AA13296@brillig.umd.edu>
Date: 21 Jul 89 20:06:44 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: Tandem Computers, Cupertino,  CA
Lines: 15
Approved: laser-lovers@brillig.umd.edu

We have a Laserwriter IINTX with 2 meg of memory. I installed a 4 meg
upgrade into the printer. It only recognizes 3 meg of total memory.

The first two banks had 256k simm modules for a total of 1 meg in each
bank. The new simms are 1 meg for a total of 4 meg. 

I'm assuming that there is a resistor to add or delete to tell the
printer that there is 4 meg in bank 2. 

Can anyone help? The memory came with no instructions, just a little
note saying that only an Apple dealer can do the installation.

E-mail or follow up post is fine.

Thanks, Leo.