Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!cs.utexas.edu!uunet!cs.dal.ca!williams
From: williams@cs.dal.ca (Trevor Williams)
Newsgroups: comp.graphics
Subject: 15 to 9 pin Analog signal conversion for NEC Multisync monitors
Keywords: NEC Multisync, ATI VGA Wonder
Message-ID: <1989Jul28.172819.9193@cs.dal.ca>
Date: 28 Jul 89 17:28:19 GMT
Organization: Math, Stats & CS, Dalhousie University, Halifax, NS, Canada
Lines: 24

Hello,
	Ok, I've just gotten my ATI VGA WONDER card, but my monitor is on back
order for about a month.  Meanwhile I'd like to use my Multisync grey scale
monitor.  The catch is that right now my monitor is set for TTL signals, which
is find so long as I don't want to use any of the VGA modes.  There is a
switch on the monitor to switch to analog input.  The rub is that the VGA 
Wonder sends its analog signal down a 15 pin connector, and all I have hooked
up to the monitor is a nine pin input.  There is no connector for a 15 pin
input.  Thus I assume that some sort of a conversion cable is required.
	Can anyone point out the pin outs for such a converter?

	Thanks,
		Paul

 Paul A. Lalonde	 UUCP: ...{uunet|watmath}!dalcs!dalcsug!lalonde
 Phone: (902)423-4748	 BITNET: 05LALOND@AC.DAL.CA			     

	"The only true law is that which leads to freedom"
			- Richard Bach, _Jonathan Livingston Seagull_
-- 
 Paul A. Lalonde	 UUCP: ...{uunet|watmath}!dalcs!dalcsug!lalonde
 Phone: (902)423-4748	 BITNET: 05LALOND@AC.DAL.CA

	"The only true law is that which leads to freedom"