Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!sun-barr!sun!imagen!atari!daisy!cplai
From: cplai@daisy.UUCP (Chung-Pang Lai)
Newsgroups: comp.lang.postscript
Subject: Re: Removing ehandler.ps Without Turning Off Power
Message-ID: <3241@daisy.UUCP>
Date: 2 Aug 89 19:52:47 GMT
References: <1992@optilink.UUCP>
Reply-To: cplai@daisy.UUCP (Chung-Pang Lai)
Organization: Daisy/Cadnetix Corp., Mtn. View, CA
Lines: 15

In article <1992@optilink.UUCP> cramer@optilink.UUCP (Clayton Cramer) writes:
]Does someone have some PostScript to restore the default error handler
]after running ehandler.ps?  

There is a switch in ehandler.ps that specify if it is used only once or
stay until power-cycle.  Look for the comment:

% Change or remove this section to use ehandler.ps on a job-by-job basis.


-- 
.signature under construction ...
{pyramid, osu-cis, uunet, killer}!daisy!cplai    C.P. Lai
cplai%daisy.UUCP@uunet.UU.NET   cplai%daisy@killer.DALLAS.TX.USA
Daisy Systems Corp, 700B Middlefield Road, Mtn View CA 94039.  (415)960-6961