Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!bbn!gatech!ncsuvx!mikes From: mikes@ncsuvx.ncsu.edu (Michael Steele) Newsgroups: comp.sys.apple Subject: Re: problems with ProTERM under System Software 5.0 Message-ID: <3585@ncsuvx.ncsu.edu> Date: 5 Aug 89 20:34:25 GMT References: <8908040733.aa10223@SMOKE.BRL.MIL> Reply-To: mikes@ncsuvx.ncsu.edu (Michael Steele) Organization: NCSU Computing Center Lines: 29 In article <8908040733.aa10223@SMOKE.BRL.MIL> V2071A@TEMPLEVM.BITNET ("George A. Piotrowski Jr.") writes: > >> I'm having a problem with running ProTERM (version 2.1) from the new GS 5.0 >> everything works fine until a beep sounds--then ProTERM immediately >> crashes into the monitor. I've tried it several times on different boards I had a similar problem which went away when I recopied P8 from my master GSOS disk. > >switch when I want to print on the laser. The problem I have encountered >is that when slot 7 is set to Appletalk, once I get connected to any BBS >or the Schools IBM, I get garbage like there is an incredible amount of >line noise. Once I set slot 7 bact to your card and reboot, Proterm >works fine. Do any of the Apple people in the System Group have any Funny I'm having that problem right now!! I just had to reboot because proterm locked up on me, now that I've rebooted everything is clean once agian (I didn't even loose my connection once I rebooted). Sound like there is some sort of problem with the new system and proterm. (BTW I still have Appletalk turned on and have a transwarp GS). Michael Steele mikes@ncsuvx.ncsu.edu -- Michael Steele mikes@ncsuvx.ncsu.edu mikes@ncsuctix.ncsuvx.ncsu.edu netoprms@ncsuvm.bitnet