Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!bionet!apple!voder!tolerant!bruce
From: bruce@tolerant.UUCP (Bruce Hochuli)
Newsgroups: comp.sys.ibm.pc
Subject: Re: 800x600 flicker?
Message-ID: <5536@tolerant.UUCP>
Date: 31 Jul 89 22:11:46 GMT
References: <36300052@iuvax>
Reply-To: bruce@handel.Tolerant.COM.UUCP (Bruce Hochuli)
Organization: Tolerant Software Inc., San Jose CA
Lines: 21

In article <36300052@iuvax> bose@iuvax.cs.indiana.edu writes:
>
>1. Does sony make a monitor that will not flicker in the higher res. modes?
Unknown
>2. Are there any large (16inch or greater) monochrome monitors that will
>   handle the 800x600 super vga mode?
>
The NEC multisynch XL is a 19" monitor that will. I had set up a system
like this for a serious AutoCad User (a mechanical engineer) and there
was no flicker at all. Yes I did run it at 800X600 and used the drivers
supplied by the adaptor vendor (Vega in this case). These cost about $2000.

There is a Mitsubishi 16" monitor and a Nanao 16" monitor that both claim
to handle super VGA. I have used the Nanao but not as super VGA. I have no
experience with the Mitsubishi but they claim higher reslotion than Nanao. 
These cost about $1000.

Someone out there, I think it is Mitsubishi but I am not sure, has a 20"
high (claimed) resolution monitor. I have never seen this one is action.

>Thanks, in advance.