Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!apple!sun-barr!decwrl!shelby!helens!relgyro!mike From: mike@relgyro.stanford.edu (Mike Macgirvin) Newsgroups: comp.sys.ibm.pc Subject: Re: Help needed in making a serial printer cable. Message-ID: <319@helens.Stanford.EDU> Date: 1 Aug 89 18:36:25 GMT References: <28202@teknowledge-vaxc.ARPA> <2479@astroatc.UUCP> Sender: news@helens.STANFORD.EDU Reply-To: mike@relgyro.STANFORD.EDU (Mike Macgirvin) Distribution: na Organization: Stanford Relativity Gyro Experiment (GP-B) Lines: 47 In article <2479@astroatc.UUCP> brown@astroatc.UUCP (Vidiot) writes: >In article <28202@teknowledge-vaxc.ARPA> 0rrodrig@teknowledge-vaxc.ARPA (Russ Rodriguez) writes: ><1 ----------> 1 ><2 ----------> 3 ><3 ----------> 2 ><4 ----------> 20 ><5 not used ><6 ----------> 11 ><7 ----------> 7 ><8-10 not used ><11 ---------> 6 ><12-19 not used ><20 ---------> 4 ><21-25 not used >You're right, it wouldn't work. The key word here is "printer" port. You >have to connect to a "serial" port. The printer port is a Centronics type Assuming you ARE using a serial port, this pinout would have a higher likelyhood of success: computer printer 2 ------------------------ 3 3 ------------------------ 2 5 -|---------------------- 20 (handshake, pin 11 sometimes) 6 -| ( see your printer manual ) 7 ------------------------ 7 |- 4 |- 5 |- 6 You might want to check out an excellent book on the subject, "The RS-232 Solution", by Joe Campbell. /*+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ + These views are my own, and my facts may not be correct. + + Mike Macgirvin + + - Systems Administrator Stanford Relativity Gyroscope Experiment (GP-B) + + - Internet: mike@relgyro.stanford.edu (36.64.0.50) + + - Bitnet: mike%relgyro.stanford.edu@stanford + + - Uucp: uunet!relgyro.stanford.edu!mike + + "'Scuse me, while I kiss the sky" - Robert James Marshall (Jimi) Hendrix + +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++*/