Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!decwrl!shlump.nac.dec.com!riscy.dec.com!fuel.dec.com!graham
From: graham@fuel.dec.com (kris graham)
Newsgroups: comp.unix.ultrix
Subject: Re: ultrix 3.1
Message-ID: <1410@riscy.dec.com>
Date: 31 Jul 89 07:04:43 GMT
References: <7463@cbmvax.UUCP> <288@edison.UUCP> <89Jul27.170604edt.30758@snow.white.toronto.edu>
Sender: news@riscy.dec.com
Lines: 37




>Install of the Ultrix 3.1 stuff is simple: backup, setld -l, rebuild
>kernel, reboot, replace customized files (if any) that were replaced.
>The UWS install sounds a lot messier.  RIS adds complications.


UWS is also very simple.

- Go into single-user mode

- Run fsck

- Unmount all file systems and remount all UFS file systems.
   #/etc/umount -a
   # /etc/mount -a -t ufs

- Run /etc/update to keep file system consistent.

- You may run the error logger...
   #/etc/eli -s

- Use 'setld' to load UWS 2.1 software.
   #/etc/setld -l /dev/nrmt*h

- run /etc/doconfig...after all desired UWS subsets are loaded.

- Move the new kernel to root (after saving the old one).

- /etc/reboot

-- 
Christopher Graham          
Digital Equipment Corp            
Ultrix Resource Center                            
New York