Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.csd.uwm.edu!cs.utexas.edu!uunet!portal!cup.portal.com!John_Mark_Shifflett
From: John_Mark_Shifflett@cup.portal.com
Newsgroups: comp.sys.amiga.tech
Subject: Re: Toolbox/2090A compatibility
Message-ID: <21465@cup.portal.com>
Date: 20 Aug 89 07:11:32 GMT
References: <15685@watdragon.waterloo.edu>
Distribution: na
Organization: The Portal System (TM)
Lines: 12

Steve:
   I've got a ToolBox (mine from Expansion Technologies) with a 2090A. 
Although the setup didn't work right the 1st few tries, it's been performing
like a champ for 5 months now. I have personally checked out ST251's and an
old Priam 80 meg (seem to have trouble with my trusty old ST225 though -
could it be too slow {65 ms} for the 2090A????). Anyways, the answer to my
initial problems was the purchase of a little bus termination card from
Expansion Tech. I plugged it onto the pass-through connector, and voila!
- perfection.  Apparently my system was just too noisy (it would hardly 
qualify as 'stock' anymore). If you get a toolbox, let me know how you
fare.....
         John Shifflett