Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!ncar!unmvax!polyslo!cosmos.acs.calpoly.edu!dhom
From: dhom@cosmos.acs.calpoly.edu (David Hom)
Newsgroups: comp.sys.apple
Subject: ORCA/C
Summary: Source level debugger problem
Message-ID: <13704@polyslo.CalPoly.EDU>
Date: 21 Aug 89 16:37:40 GMT
References: <3003@cbnewsm.ATT.COM>
Sender: news@polyslo.CalPoly.EDU
Reply-To: dhom@cosmos.acs.calpoly.edu.UUCP (David Hom)
Organization: Cal Poly State University -- San Luis Obispo
Lines: 20

I just purchased ORCA/C installed it on my hard disk and started to
get acquainted with the desktop environment (I previously owned ORCA/M).
Everything ran fine. I compiled bullseye.cc.  When running the debugger
step and trace ran fine.  When I set auto-go, the green dots appeared,
but when stepping through the code, it still stepped line by line through
the area I set for auto-go.  Then I tried to set a breakpoint.  The purple
"X" appeared, but when tracing through the code, the run did not stop at
the breakpoint.

I tried this several times then tried it on the original disks shipped to
me with the same results--markers came up correctly, but the functions
did not work.

Has anyone else had this problem with ORCA/C?  Any help would be greatly
appreciated.


David

dhom@cosmos.acs.calpoly.edu