Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!ames!indri!polyslo!cosmos.acs.calpoly.edu!dhom
From: dhom@cosmos.acs.calpoly.edu (David Hom)
Newsgroups: comp.sys.apple
Subject: Re: ORCA/C
Message-ID: <13706@polyslo.CalPoly.EDU>
Date: 22 Aug 89 01:32:56 GMT
References: <3003@cbnewsm.ATT.COM> <13704@polyslo.CalPoly.EDU>
Sender: news@polyslo.CalPoly.EDU
Reply-To: dhom@cosmos.acs.calpoly.edu.UUCP (David Hom)
Organization: Cal Poly State University -- San Luis Obispo
Lines: 17

In article <13704@polyslo.CalPoly.EDU> I write:

>step and trace ran fine.  When I set auto-go, the green dots appeared,
>but when stepping through the code, it still stepped line by line through
>the area I set for auto-go.  Then I tried to set a breakpoint.  The purple
>"X" appeared, but when tracing through the code, the run did not stop at
>the breakpoint.
>

I got a couple email responses to this posting voicing the same problem.  I
call Byteworks today.  They know about the problem and will be releasing a
free update to registered owners of Orca/C (so send in your registration cards.)


David

dhom@cosmos.acs.calpoly.edu