Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!ames!sun-barr!rutgers!orstcs!jacobs.CS.ORST.EDU!throoph
From: throoph@jacobs.CS.ORST.EDU (Henry Throop)
Newsgroups: comp.sys.apple
Subject: Re: Esoniq A/D port
Message-ID: <12318@orstcs.CS.ORST.EDU>
Date: 31 Aug 89 23:51:05 GMT
References: <8908301858.AA21821@trout.nosc.mil> <34459@apple.Apple.COM>
Sender: usenet@orstcs.CS.ORST.EDU
Reply-To: throoph@jacobs.CS.ORST.EDU.UUCP (Henry Throop)
Organization: Oregon State University - CS - Corvallis Oregon
Lines: 16

In article <34459@apple.Apple.COM> dlyons@Apple.COM (David Lyons) writes:
|In article <8908301858.AA21821@trout.nosc.mil> j_p@pro-lep.cts.com (Jason Perez) writes:
||I got a program called AFOSC from Apple2-L and it says it will take an
||input from the Esonig A/D port and show it on its oscilloscope emulator.  But
||I'm confused as to where/what is the Esoniq A/D input port.  Pleas post any
||help as I would appreciate it.
|
|The Ensoniq connector is the 6(?)-pin one next to the Ensoniq chip, near the
|front right of the motherboard (you gots to go inside the hood for this one).


That's actually a 7-pin connector.  For the oscilloscope program you have,
you need to use pins 1 and 2, the ones closest to the front of teh computer.
Pin 1 is analog input, +2.5V maximum, and pin 2 is ground.

Henry