Path: utzoo!attcan!uunet!lll-winken!brutus.cs.uiuc.edu!tut.cis.ohio-state.edu!gem.mps.ohio-state.edu!ginosko!usc!henry.jpl.nasa.gov!elroy.jpl.nasa.gov!zardoz!everex!mb From: mb@everex.UUCP (Michael Burg) Newsgroups: comp.unix.i386 Subject: Re: SCSI with 386/ix Message-ID: <594@everex.UUCP> Date: 22 Aug 89 07:15:34 GMT References: <803@digiw.UUCP> Reply-To: mb@everex.UUCP (Michael Burg, OS Group) Organization: Everex Systems Inc., Los Alamitos, CA Lines: 24 In article <803@digiw.UUCP> petri@digiw.UUCP (Petri Alhola) writes: >In article ojala@cs.hut.fi writes: >> >>The Enix didn't include any SCSI drivers, [goes on about 386/ix] >The old version of Enix included SCSI drivers , they are missing >from current version, and i do not know why ?? , are they so >buggy that they cat be in stantard distribution ? . Because they never really worked and because they weren't supposed to be shipped. The upcomming Revision C (due out in about 2 to 3 weeks at this point) will include a fully working SCSI hard disk driver (support via the AHA1540/42A controller). Support for 9 track and cartridge tape devices are supported along with booting from a SCSI disk. Also a note about the Adaptec AHA1540/42A controller, the lastest version of the board(s) will work with the Everex Step Series computers, however, the motherboards must be at least at G2 revision or higher. ------------------------------------------------------------------------------- Mike Burg, Unix Division, ESIX/Everex Systems Inc. Voice: (213) 493-3749 10525 Humbolt Street Los Alamitos, CA 90720 Fax: (213) 431-3878 UUCP: uunet!zardoz!everex!mb or ucbvax!ucivax!felix!everex!mb