Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!pt.cs.cmu.edu!cadre.dsl.pitt.edu!pitt!darth!investor!root
From: root@investor.pgh.pa.us (Bob Peirce #305)
Newsgroups: comp.dcom.modems
Subject: Control Characters over Telebit modems
Message-ID: <1989Sep4.162531.28089@investor.pgh.pa.us>
Date: 4 Sep 89 16:25:31 GMT
Reply-To: rbp@investor.pgh.pa.us (Bob Peirce #305)
Distribution: usa
Organization: Cookson, Peirce & Co.
Lines: 12

I don't know if this happens with any other control characters, but
when I dial in from one Telebit to another on "FAST" and run uEmacs,
a ^P is not acted upon until after another key is struck.  For example,
a ^P does nothing.  A second ^P causes the cursor to move up two lines.

This does not happen if I dial in at a slow speed or if I dial in to
a 1200 baud modem, just when it is Telebit to Telebit at high speed.
Both dial in ports have the same stty parameters except for baud rate.
The high speed port is set to 9600 and the low to 1200.  The modem
connected to my terminal is set to 19200.

Has anybody else encountered this problem?  Is there a solution?