Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!apple!brutus.cs.uiuc.edu!tut.cis.ohio-state.edu!gem.mps.ohio-state.edu!rpi!crdgw1!uunet!van-bc!
From: lphillips@lpami.wimsey.bc.ca (Larry Phillips)
Newsgroups: comp.sys.amiga.tech
Subject: Re: WB 1.3 Epson LQ driver doesn't!
Message-ID: <745@lpami.wimsey.bc.ca>
Date: 7 Sep 89 14:53:06 GMT
Lines: 19
Return-Path: <lpami!lphillips>
To: van-bc!rnews

In <1989Sep7.090753.2043@jarvis.csri.toronto.edu>, edgar@csri.toronto.edu (Edgar LeBel) writes:
> ... Before I pull pin 14 out of my parallel cable, I would 
>just like to confirm that this will solve the problem.  The 
>documentation of pin 14 in my manual is cryptic (1 line of text). 
>Will disabling this pin make the printer interpret LF,CR as a single LF?

Pulling pin 14 will do it, provided the correesponding DIP switch is set properly.
AT any rate, it can do no harm whatsoever, even if the problem were something
else, such as a bogus driver.

-larry

--
The Mac? Oh, that's just like a computer, only slower.
+-----------------------------------------------------------------------+ 
|   //   Larry Phillips                                                 |
| \X/    lphillips@lpami.wimsey.bc.ca -or- uunet!van-bc!lpami!lphillips |
|        COMPUSERVE: 76703,4322  -or-  76703.4322@compuserve.com        |
+-----------------------------------------------------------------------+