Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!cornell!uw-beaver!ssc-vax!shuksan!tahoma!prl3546
From: prl3546@tahoma.UUCP (Philip R. Lindberg)
Newsgroups: comp.sys.apple
Subject: Re: Tulin Case Review
Message-ID: <594@tahoma.UUCP>
Date: 30 Aug 89 15:12:53 GMT
References: <8908290228.AA02285@trout.nosc.mil>
Organization: The Boeing Co., BCA FSL, Seattle, WA
Lines: 33

From article <8908290228.AA02285@trout.nosc.mil>, by bobl@pro-graphics.cts.com (System Administrator):
> 
> Recently I received the Tulin Corp (408) 432-9025  A-Hive hard drive
> [...]
> are my initial impressions and assembly comments.
 
	I also built my "homebrew" 60meg. HDrive using a ST277N and an
A-Hive case from Tulin.
 
>  5) Forget the drive select LED jumperwires, I couldn't find any place to
>     attach it on the ST277N.  The green power LED was all I could hook up, so
>     you won't see the drive select light come on.

Up until now your instructions have been fine, but I have another suggestion
here.  I tried to follow their instructions on the LED wires but found it
"hokey".  What I ended up doing is soldering two wires to the pads on the
other side of the drive card were it's access light is, and connecting them
to a new LED I mounted to the front panel.  This way I have both power and
access lights.  (I also replaced the power switch, but that is not as
important.)

> 
> _______________________ Pro-Graphics  201/469-0049 __________________________


+---------------------------------------------------------+
|	     The Apple //'s will live forever!!		  |
|  Phil Lindberg	    snail mail: 13845 S.E. 131 ST |
| INET: prl3546@tahoma.UUCP		Renton, WA 98056  |
| UUCP: ..!uw-beaver!ssc-vax!shuksan!tahoma!prl3546	  |
|    Disclaimer: I don't speak for my employer (and I not |
|		 sure they even know I exist....)	  |
+---------------------------------------------------------+