Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!sun-barr!apple!bloom-beacon!tut.cis.ohio-state.edu!ucbvax!AECLCR.BITNET!01659
From: 01659@AECLCR.BITNET (Greg Csullog)
Newsgroups: comp.sys.atari.st
Subject: PC Ditto II and the SLM804
Message-ID: <8909092229.AA11377@ucbvax.Berkeley.EDU>
Date: 9 Sep 89 22:30:00 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 12

I have heard reports that Ditto II is supposed to allow printing to the
SLM804 laser. I hope this is true. I use a '286/'287 PC at work and it is
a real pain waiting 10 to 20 minutes for detail graphics to print out on
an HP laserjet via the parallel port. The same GEM pic that took l{14 min 55 sec
on the PC took only 45 seconds from a Mega 2 to the SLM804 (unfortunately,
the SLM804 is not in my work area or I would use it instead of the PC/HP
combo). With Ditto II, I could run GEM Draw on my ST and print it to an
SLM804. That way, I could justify getting an SLM804 in my work area (with
Spectre GCR I can print Mac stuff to the SLM804 as well, not to mention
lots of ST code output).

Question: Does Ditto II support the SLM804?????