Path: utzoo!attcan!uunet!mcsun!sunic!tut!ra!chyde!ts
From: ts@chyde.uwasa.fi (Timo Salmi LASK)
Newsgroups: comp.sys.ibm.pc
Subject: Re: Telix and Kermit
Message-ID: <749@chyde.uwasa.fi>
Date: 10 Sep 89 07:24:36 GMT
References: <14190@netnews.upenn.edu>
Reply-To: ts@chyde.uwasa.fi (Timo Salmi LASK)
Organization: U of Vaasa, Finland
Lines: 20

In article <14190@netnews.upenn.edu> ferris@eniac.seas.upenn.edu.UUCP (Richard  Ferris) writes:
>I have been trying to do file transfers from my school's mainframe
>to my PC by modem using the Kermit in Telix.  I have been successful
>in text mode but I can't get it to transfer in binary mode.  I have
>set Telix in binary mode and I set the mainframe kermit to binary
>mode also.  I have done this identical procedure and been successful
>using the Kermit in Procomm.  Any ideas.  Thanks.

What baud rate were you using when trying Kermit in Telix? If it was
high, problems occur. There are several solutions:
  1) Lower the baud rate (not a good one)
  2) Use zmodem transfer in Telix
     - this works well when one gets it right. You must have 
       zmodem at both ends
  3) Use MsKermit program and Kermit transfer Protocol.

...................................................................
Prof. Timo Salmi                                (Site 128.214.12.3)
School of Business Studies, University of Vaasa, SF-65101, Finland
Internet: ts@chyde.uwasa.fi Funet: vakk::salmi Bitnet: salmi@finfun