Path: utzoo!censor!geac!jtsv16!uunet!lll-winken!brutus.cs.uiuc.edu!wuarchive!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!TEMPLEVM.BITNET!V2071A
From: V2071A@TEMPLEVM.BITNET ("George A. Piotrowski Jr.")
Newsgroups: comp.sys.apple
Subject: Re: Recognizing the second drive
Message-ID: <8909182204.ab02410@SMOKE.BRL.MIL>
Date: 19 Sep 89 01:55:18 GMT
References: <eddie@CC.MSSTATE.EDU>
Organization: The Internet
Lines: 30


> I followed the instructions for generating a system disk that will print
> to a Laserwriter on an appletalk network.  Tested the disk and it sends
> stuff to the printer just fine.
>
> Here's the problem.  When I boot with this printer disk, the system does
> not recognize my 5.25 disk!  Just to make sure I had not damaged the
> 2nd drive somehow, I rebooted using the normal System.Disk, which
> recognized the 5.25 disk just fine.
>
> Anyone else run into this problem, or can anyone make any suggestion on
> what I've done wrong?

Eddie,

     What you probably haven't done is installed the driver for the 5.25"
disk drive.  Use the installer program, and install the Appledisk.5.25
driver onto your printer disk.  Then reboot.  All should be fine.

Good Luck & Bye for now,
________________________________________________________________________

George A. Piotrowski                       Bitnet:     V2071A@TEMPLEVM
Coordinator, Educational Computing Cntr    Genie:      G.PIOTROWSKI
Temple University                          CompuServe: 74046,1304
Philadelphia, PA 19122   (215) 787-6228

The opinions expressed are my own and do not have anything to do with
Temple University. (well, not much)
________________________________________________________________________