Xref: utzoo comp.unix.aix:17 comp.sys.ibm.pc.rt:967
Path: utzoo!attcan!uunet!ibmarc!griefer
From: griefer@ibmarc.uucp (Allan D. Griefer)
Newsgroups: comp.unix.aix,comp.sys.ibm.pc.rt
Subject: Re: RT running AIX w/Ethernet card....suggestions wanted.
Keywords: Ungermann Bass card, RT, AIX, etc
Message-ID: <1086@ks.UUCP>
Date: 21 Sep 89 22:49:53 GMT
References: <12724@s.ms.uky.edu>
Sender: news@ibmarc.UUCP
Reply-To: griefer@ibmarc.UUCP (Allan D. Griefer)
Organization: IBM Almaden Research Center
Lines: 16

This could be caused by a couple of things:

1.  Did you install the Baseband (Ethernet) Device Driver from the
	VRM Device Driver diskette during installation?

2.  In devices, you need to choose adapters after add and then
	net, for ethernet.

When you finally add the device, make sure that the interrupt level and the
storage addresses specified match the card plugging;  the defaults are not
always the same on both the card and the command.

Opinions are strictly my own,
Allan D. Griefer,       IBM Almaden Research Center, San Jose, CA
BITNET: GRIEFER at ALMADEN              Internet: griefer@ibm.com
UUCP: ...!uunet!ibmarc!griefer