Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!uwm.edu!uakari.primate.wisc.edu!aplcen!haven!adm!xadmx!CSSNET%NUSDISCS.BITNET@cunyvm.cuny.edu
From: CSSNET%NUSDISCS.BITNET@cunyvm.cuny.edu
Newsgroups: comp.unix.questions
Subject: TCP/IP
Message-ID: <21091@adm.BRL.MIL>
Date: 10 Oct 89 14:28:23 GMT
Sender: news@adm.BRL.MIL
Lines: 29



         Wollongong Integrated Networking WIN/3B: Release 2.1
         AT&T 10base5 Network Interface (NI) Package: Release 1.1

         We are running the above on our AT&T 3B4000/15 and have been experienci
ng
         frequent "crash" on the network. To bring the network up, we have been
         using sysadm netstart. However there are times where we had to start an
d
         shut several times before we establish the network correctly (able to
         telnet). Also, we had taken the default configuration of 8 ttyp ports b
ut
         sometimes when there's only 5 ports used, users are given the message
         "All network ports in use" when they try to telnet or rlogin into the
         system.

         Usually when we are desperate, we just reboot the whole system...works
         perfectly so far!!

         I am just hoping that there are users who had this problem and if there
's
         some better solutions to it.

         Thanks.

        > Sim Ser Ngarn (Jnet%"SIMSN@NUSDISCS")
        > National University of Singapore
        > Department of Information Systems and Computer Science