Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!uwm.edu!bbn!news
From: news@bbn.COM (News system owner ID)
Newsgroups: comp.os.cpm
Subject: Cromemco Help
Message-ID: <46896@bbn.COM>
Date: 13 Oct 89 17:25:48 GMT
References: <1989Oct13.072304.661@ccu.umanitoba.ca>
Reply-To: gonzalez@vax.bbn.com (Jim Gonzalez)
Organization: Bolt Beranek and Newman Inc., Cambridge MA
Lines: 15

My first attempt to post this inquiry apparently failed.  
From: gonzalez@bbn.com (Jim Gonzalez)
Path: bbn.com!gonzalez

I am in the process of interfacing a Shugart SA 801 drive to a Cromemco
16FDC controller.  The signal assignment on the 16FDC connector is not
consistent with that of the SA 801; Cromemco apparently adopted a non-
standard pattern.  Wayne Hortensiu supplied me with information about 
jumpers and trace cuts, which I have followed.  I have had some success, 
but have questions about the error messages printed by the ROM monitor 
when I attempt to access the drive.  Attempts to reach Wayne by email 
have failed.  If Wayne (or anyone else familiar with the 16FDC and the
RDOS II monitor) would contact me, I would appreciate it.  Thanks.

				-Jim.