Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!uunet!cbmvax!daveh From: daveh@cbmvax.UUCP (Dave Haynie) Newsgroups: comp.sys.amiga Subject: Re: SetCPU wipes out Path Message-ID: <8267@cbmvax.UUCP> Date: 25 Oct 89 15:06:02 GMT References: <916@sdrc.UUCP> Organization: Commodore Technology, West Chester, PA Lines: 26 in article <916@sdrc.UUCP>, evgabb@sdrc.UUCP (rob gabbard) says: > Keywords: setcpu amiga path > I've just started the SetCPU utility on my A2500. I've got the following > in my boot:s/startup-sequence: > SetCPU FASTROM CARDROM > It seems to work OK except that the Path command that I also have in > there doesn't work :-( Any shells I start up have the default path. Apparently in some setups, the change SetCPU makes to the ROM to display "Fastbench" instead of "Workbench" causes the path to get lost. This never happens on either of my systems, so I'm at a loss to explain just what's at work here. However, the simple workaround is to run without the patches installed: SetCPU NOPATCH FASTROM CARDROM That should take care of any path-loss problems. > Rob Gabbard (uunet!sdrc!evgabb) _ /| -- Dave Haynie Commodore-Amiga (Systems Engineering) "The Crew That Never Rests" {uunet|pyramid|rutgers}!cbmvax!daveh PLINK: hazy BIX: hazy Too much of everything is just enough