Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!pacific.mps.ohio-state.edu!zaphod.mps.ohio-state.edu!gem.mps.ohio-state.edu!wuarchive!brutus.cs.uiuc.edu!ginosko!cs.utexas.edu!uunet!van-bc!rsoft!mindlink!a195
From: a195@mindlink.UUCP (Robert Hardy)
Newsgroups: comp.sys.amiga.tech
Subject: Help with Disk Changed messages
Message-ID: <633@mindlink.UUCP>
Date: 25 Oct 89 23:58:38 GMT
Organization: MIND LINK! - British Columbia, Canada
Lines: 24

Hi Guys.  I'm putting the finishing touches on my disk catalog program and
I've run into a rather puzzling problem.  The program is intended to cycle
through selected devices (df0:, df1:....)  and continue calaloging till there
is no new disk in the selected drives.  The IDCMP send me the messages fine
(DISKINSERTED & DISKREMOVED) until I've started reading the directory's.
Once it starts reading no more messages.  The best I can figure is that
either I'm doing something wrong when reading the directory or I'm not
doing something I should after reading.  Any Ideas?

Thanks for the help

Bob.


Being a Progammer is never having to say you're finished
=====================================================================
|    |  |  /                                                        |
|    |  | /                                                         |
|    |__|/                                                          |
|    |  |\                                                          |
|    |  | \                                                         |
|    |  |  \   HardKore Software                                    |
|    |  |   \                                                       |
=====================================================================