Path: utzoo!censor!perle!yarko
From: yarko@perle.UUCP (Yarko Matkiwsky)
Newsgroups: comp.sys.ibm.pc
Subject: 3.5" floppy drives for AT compatibles
Message-ID: <784@perle.UUCP>
Date: 26 Oct 89 18:07:58 GMT
Reply-To: yarko@perle.UUCP (Yarko Matkiwsky)
Distribution: world
Organization: Perle Systems Limited  Scarborough, Ontario, Canada
Lines: 15

I am using an AT clone (VLSI chip set) and have attached a 3.5" floppy
drive to it.  I use setup to specify this as the A drive and my 5.25"
1.2Meg floppy as the B drive.  I boot DOS 4.0 for the 40 meg hard disk.

My problem is that I can do a "dir" on a floppy in the 3.5" (720K) drive 
but when I remove that disk and put in another different disk and do a 
"dir" the directory of the first disk is read.  It is as if I didn't remove
the first disk.

Any Ideas!?  I have swapped the 5.25" and the 3.5" floppies around and the
problem still remains on the 3.5" drive.  The 5.25" works fine.
-- 
Yarko Matkiwsky                               370A Tapscott Rd.
Perle Systems Limited                         Scarborough, Ont.
UUCP: ...!uunet!mnetor!perle!yarko            Canada   M1B 3C4