Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!uwm.edu!cs.utexas.edu!tut.cis.ohio-state.edu!husc6!endor!siegel
From: siegel@endor.harvard.edu (Rich Siegel)
Newsgroups: comp.sys.mac.programmer
Subject: Re: Continual beeping when exiting from Think C Programs
Keywords: Think C, MultiFinder, Frustration
Message-ID: <2978@husc6.harvard.edu>
Date: 26 Oct 89 14:21:29 GMT
References: <59993@aerospace.AERO.ORG>
Sender: news@husc6.harvard.edu
Reply-To: siegel@endor.UUCP (Rich Siegel)
Distribution: usa
Organization: Symantec Language Products Group
Lines: 27

In article <59993@aerospace.AERO.ORG> crawford@aerospace.aero.org (Kirk B. Crawford) writes:

>Sometimes when I am running Think C under Multifinder (3.0 and 4.0)
>and then I run the project on top of Think C, and then quit the
>program (the one I am developing).  The mac beeps continually,
>sometimes at a high rate, sometimes at a very slow rate.  This problem

	Are you using OnCue? If so, you should only use OnCue to launch
an application directly, and NOT to launch documents; there's a bug in
OnCue which will cause the behavior you described.

R.




~~~~~~~~~~~~~~~
 Rich Siegel
 Staff Software Developer
 Symantec Corporation, Language Products Group
 Internet: siegel@endor.harvard.edu
 UUCP: ..harvard!endor!siegel

"There is no personal problem which cannot be solved by sufficient
application of high explosives."

~~~~~~~~~~~~~~~