Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!wuarchive!gem.mps.ohio-state.edu!tut.cis.ohio-state.edu!pt.cs.cmu.edu!rochester!kodak!elmgate!jeh
From: jeh@elmgate.UUCP (Ed Hanway)
Newsgroups: comp.sys.amiga
Subject: Re: Assistance required... A2000 with hardframe
Summary: Try removing terminating resistors.
Keywords: HardFrame BindDrivers
Message-ID: <1157@elmgate.UUCP>
Date: 8 Nov 89 20:33:19 GMT
References: <8911040357.AA07220@jade.berkeley.edu>
Sender: jeh@elmgate.UUCP
Reply-To: jeh@elmgate.UUCP (Ed Hanway)
Organization: Eastman Kodak Company, Rochester, NY
Lines: 14

In article <8911040357.AA07220@jade.berkeley.edu> CRONEJP@UREGINA1.BITNET (Jonathan Crone) writes:
>When attempting to Binddrivers the hardframe software into
>the system, a system lock fails and gurus the System immediately
>after initial access to hard drive.
>
>Drive is set as Unit 0, a boot attempt at any other drive fails with
>a drive not found system freeze. (no guru, but the binddrivers
>never returns.)

Try removing the terminating resistors from the HardFrame board. They're
two socketed resistor SIPs located on the edge of the board next to the
ribbon cable.

The usual disclaimer applies: it worked for me, but try it at your own risk.