Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!gem.mps.ohio-state.edu!brutus.cs.uiuc.edu!rpi!nyser!rodan!isr
From: isr@rodan.acs.syr.edu ( ISR group account)
Newsgroups: comp.sys.mac
Subject: Re: Mac IIci and third party hard drives...
Message-ID: <1292@rodan.acs.syr.edu>
Date: 9 Nov 89 16:26:30 GMT
References: <676@crash.cts.com>
Reply-To: isr@rodan.acs.syr.edu (Michael S. Schechter - ISR group account)
Organization: Small blue alien techno-thiefs invading your Planet
Lines: 16

>Who the hell makes this off the wall connector and what is the part number?  I
>looked through the AMP and Molex catalogs, there is no such beast unless it's
>a very new connector.

I had a similar problem with the SE analog-to-motherboard connectors. I wanted
to run with the motherboard outside so i could debug an expansion card i'm
working on.. I coudn't find it anywhere, but it wasn't that hard to get one
after all, I just went down to the local dealer and ordered a replacement
cable and cut it in half. I'm sure you could do the same for the drive cable.
    :-)  cheer up, you could be using DOS, don't forget :-)



-- 
 Mike Schechter, Institute for Sensory Research, Syracuse Univ.
InterNet: isr@rodan.syr.edu  msschech@rodan.syr.edu  Bitnet: SENSORY@SUNRISE