Path: utzoo!attcan!uunet!aplcen!uakari.primate.wisc.edu!gem.mps.ohio-state.edu!pacific.mps.ohio-state.edu!tut.cis.ohio-state.edu!dsac!dcscg1!dgaulden
From: dgaulden@dcscg1.UUCP (David E. Gaulden)
Newsgroups: comp.sys.ibm.pc
Subject: Re: WX1
Keywords: Controller BIOS
Message-ID: <625@dcscg1.UUCP>
Date: 20 Nov 89 18:04:49 GMT
References: <[255debd6:18]comp.sys.ibm.pc@tronsbox.UUCP> <[2563d6c7:18.1]comp.sys.ibm.pc;1@tronsbox.UUCP>
Reply-To: dgaulden@dcscg1.dcsc.dla.mil.UUCP (David E. Gaulden)
Organization: Defense Construction Supply Center, Columbus
Lines: 12

In article <[2563d6c7:18.1]comp.sys.ibm.pc;1@tronsbox.UUCP> akcs.graf_e@tronsbox.UUCP (Graf Eberstein) writes:
>>Does anyone know the DEBUG commands to get the WX1 low-level stuff to run?
>>It is on the WX1 ROM somewhere...

Most 8 BIT WD controllers use G=C800:5.  Adaptec 8 BIT RLL uses G=C800:ccc.
Most 16 BIT controllers use G=C800:5.  Some 16 BIT controllers have the
ability of changing the load address to D800.
-- 
------------------------------------------------------------------------------ 
 IRL:Dave Gaulden                    |     "Man who says, 'It cannot be done', 
     DCSC Columbus, Ohio             |      Should not interrupt man who is    
     dgaulden@dcsc.dla.mil           |      doing it."