Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucsd!ucrmath!jarob
From: jarob@ucrmath.UCR.EDU (Karl Bunch, Unix Security Specialist)
Newsgroups: comp.sys.tandy
Subject: How do you hookup 8" Model 16/6000 Drives to a Tandy 4000?
Keywords: 6000 8" floppy
Message-ID: <2722@ucrmath.UCR.EDU>
Date: 23 Nov 89 17:54:00 GMT
Reply-To: root%ttank@ucrmath.edu
Organization: University of California, Riverside
Lines: 20

We still have a lot of customers that are using the 6000/16s and we
currently shutdown our only in-house 6000.  I would like to write
software to drive a 8" disk drive on our in-house 4000 using either
the motherboard floppy ctlr or even another controller hooked up as
a card etc..  But, I need cable requirements etc..

I remember writting code to convert from the old vax 8" drives to
Tandy 8" drives and it was a lot of fun but very useful when done!

I would rather all this be able to run under SCO Xenix.

Any suggestions? Anybody?  :-)

Karl Bunch
Think Tank Software

-- 

--------------------------------------------------------------------------------
UUCP:   ..!ucbvax!ucdavis!tts!root	ARPA:   jarob@ucrmath.edu