Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!wuarchive!brutus.cs.uiuc.edu!uakari.primate.wisc.edu!ames!haven!decuac!shlump.nac.dec.com!engles.enet.dec.com!powers
From: powers@engles.enet.dec.com (Bill Powers)
Newsgroups: comp.sys.atari.st
Subject: Re: Placement of TOS 1.4
Message-ID: <6578@shlump.nac.dec.com>
Date: 4 Dec 89 14:24:21 GMT
References: <8912030811.AA08915@ucbvax.Berkeley.EDU>
Sender: newsdaemon@shlump.nac.dec.com
Reply-To: powers@engles.enet.dec.com (Bill Powers)
Organization: Digital Equipment Corporation
Lines: 45

In article <8912030811.AA08915@ucbvax.Berkeley.EDU>,
asqb-sep-a@HUACHUCA-EMH2.ARMY.MIL (ASQB-SEP-A HQ USAISEC) writes:
> I was wondering if anyone can help me with the correct placement of
> the TOS 1.4 chips?
> 
> I tried two different iterations:
> 
>       A.    L0
>             L1
>             L2
>             H0
>             H1
>             H2
> 
>       B.    L0
>             H0
>             L1
>             H1
>             L2
>             H2
> 

     This problem hit me too, when I received my chips via mail, all I got
was the 6 chips.  Don't pay any attention to the L&H numbers, there are 
other numbers on the chip, that read in ascending order.  There are 
equivalent numbers on the roms that are already on the 1.0 roms.  You need
to put the new eproms in the same ascending order.  I can't remember
the exact pattern that resulted of the L&H numbers, but was one of the
following on my 1040st.

  H2 H1 H0
  L2 L1 L0

     or

  H0 H1 H2
  L0 L1 L2

Bill Powers
----
Digital Equipment Corp. - Advanced Service Delivery Systems - Stow MA
The opinions expressed above are my own, not my employers, so there.
TELEPHONE - (508) 496 - 8725
E-MAIL - powers@harpo.enet.dec.com
       - ...!decwrl!harpo!powers