Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!CIE.UOREGON.EDU!kevins
From: kevins@CIE.UOREGON.EDU
Newsgroups: comp.sys.ibm.pc
Subject: Never ending lights to drive by...
Message-ID: <8911280121.AA16481@cie.uoregon.edu>
Date: 28 Nov 89 01:21:05 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Lines: 25


 
I recently purchased a 286 hard drive controller from a local
outlet and am having some problems.  The card is a PTI-213 286
HDS card made by Datatech Enterprises.  The documentaion is 
as sparse as possible, however it does use the Western Digital
Chip set.
 
The problem is that the lights on the drives stay lit all the
time depending on which drive was last accessed.  Thus the light
on the C: drive will stay lit until the D: drive is accessed, then
the D: light will stay lit....
Is this a major problem?  
 
I also cannot get the external LED to work using the 4 pin 
connector on the card.  Anyone have any thoughts?
 
I returned the card once and got a replacement, but the replacement
acts just the same as the first one.
 
Suggestions??
 
kevins@cie.uoregon.edu
 
(Please email your replies as I am unable to keep up here)