Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!wuarchive!udel!rochester!kodak!ektools!isctsse!fuller
From: fuller@kadsma.uucp (Bill Fuller)
Newsgroups: comp.sys.ibm.pc
Subject: IBM parallel interface.
Message-ID: <1989Dec1.215634.666@kadsma.uucp>
Date: 1 Dec 89 21:56:34 GMT
Sender: daemon@ektools (The Devil Himself)
Reply-To: fuller@kadsma.UUCP ()
Distribution: usa
Organization: Eastman Kodak Telecommunication Services, Rochester, N.Y. 14650
Lines: 15

Hi,

	I am about to embark on a project where I will be taking a feed
from a parallel printer and manipulating it.  I know that I could run
the feed through a parallel to serial converter and then easily absorb
the input through a standard asynch com line.  My question is whether
or not it is possible to take in input from a parallel interface, and if
so, how do you do it.  I remember seeing an article about someone doing file
transfers at very high speeds between two parallel ports, but I don't
remember how they accomplished this.

		Any help is appreciated.

		William H. Fuller
		fuller@kodak.kadsma.com