Xref: utzoo comp.sys.mac.hypercard:2805 comp.sys.mac:43113 Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!samsung!think!husc6!spdcc!merk!alliant!linus!cvbnet!aperez From: aperez@cvbnet.UUCP (Arturo Perez x6739) Newsgroups: comp.sys.mac.hypercard,comp.sys.mac Subject: Printing on Index Cards? Message-ID: <222@cvbnet.Prime.COM> Date: 28 Nov 89 16:11:00 GMT Sender: postnews@cvbnet.Prime.COM Lines: 43 Second attempt at getting an answer to this: I have a stack that I would like to print onto 3x5 (or, if that's impossible, 5x8) index cards using an ImageWriter II. The problems I've run into are: 1) The background of cards in HyperCard cannot be changed in size to be smaller that 5x8. If you make a card that's smaller than the background then when it's printed, all the blank space around the card is "printed" as well, leading to a horrible waste of paper. Is there anyway to make the background smaller, or at least not print? 2) In "Page Setup" within HyperCard, the 50% reduction item is eliminated. So now I can't print a single card from the stack in anything but full size. Anyway around this? 3) The ImageWriter II doesn't seem to understand the size of index cards. I would like to be able to configure the printer to print onto the index cards, i.e. tell it that it is printing onto 3x5 (or 5x8) paper which can be either pin-feed or tractor feed. Is there any way to configure the ImageWriter to print onto things other than 8x11 paper? Is there a software solution? Do I have to write an ImageWriter driver to do this? I also have lots of insoluble problems (e.g. the carriage isn't wide enough to print on paper larger than ~10x??) that I can accept. Any and all solutions welcome. I'm a hardcore C programmer (Unix & VMS background) so if I have to write a driver then I have to write a driver... Arturo Perez aperez@cvbnet.prime.com ComputerVision, a Prime Business Unit (617) 275-1800 x6739 "Too much information, like a bullet through my brain!" - The Police