Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!uunet!zephyr.ens.tek.com!tekcrl!tekfdi!videovax!dougs
From: dougs@videovax.tv.tek.com (Doug Stevens)
Newsgroups: comp.sys.ibm.pc
Subject: MKS vi 3.1 versus Desqview 2.25
Keywords: MKS vi Desqview
Message-ID: <5643@videovax.tv.tek.com>
Date: 7 Dec 89 00:39:10 GMT
Distribution: na
Organization: Tektronix TV Measurement Systems, Beaverton OR
Lines: 15

------

Just got my new version of vi from MKS (version 3.1). 
It's extremely nice, but whenever I run it under Desqview, the
cursor moves to the top line of the screen and then marches to the
right at about 1 character per second; there is no response to
any of the commands. My only option is to close the window.

I'm running on an NEC Powermate 386 (16 Mhz) under DOS 3.2.
The behavior is the same even when I remove every TSR in the system.

Old vi (version 2.3b) works fine. Am I doing something wrong in
Desqview? I've tried practically every option imaginable, but
if you've seen this problem and can suggest a solution, I would
be eternally grateful (or at least until tomorrow).