Xref: utzoo alt.msdos.programmer:880 comp.sys.tandy:1893 comp.sys.ibm.pc:39778
Path: utzoo!attcan!uunet!lll-winken!brutus.cs.uiuc.edu!psuvax1!psuvm!dgh103
From: DGH103@PSUVM.BITNET
Newsgroups: alt.msdos.programmer,comp.sys.tandy,comp.sys.ibm.pc
Subject: HELP!!!!!!
Message-ID: <89346.001555DGH103@PSUVM.BITNET>
Date: 12 Dec 89 05:15:55 GMT
Organization: Penn State University
Lines: 28

Ok, I don't think that I explained myself very well the last time I posted this
message. I will try to explain it better this time. I have a Tandy 1400LT and
for some reason they have the modem and the com port attached together,
consequently I cannot use the modem and the mouse at the same time, but that's
not the problem. What I want to do is write a program that I will run when I am
going to use ProComm that will switch from the com port to the modem. I have
the service manual for the 1400 and I am a little lost. I will show how thw pag
e looks:
                          I/O Address Map
System Status Register

    Address         Bit      Contents                      Control

(Write Register)
    0FCH             2       Modem/RS-232C Switch        1/Modem,0/RS-232C

I guess I should explain that to switch between them now I have to use the
CTRL-ALT-INS key sequence to get to a setup menu then switch to the one I want.

Can anyone help me? Any help would really be appreciated!!

-------
*************************************************************************
* Darryl G. Hickson                  Penn State University              *
* 761 Stratford Drive                DGH103@PSUVM.BITNET                *
* State College, PA 16801                                               *
* (814) 867-2234                                                        *
*************************************************************************