Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!umich!samsung!zaphod.mps.ohio-state.edu!uwm.edu!psuvax1!psuvm!UNLVAX1!HULL
From: HULL@UNLVAX1.BITNET
Newsgroups: bit.listserv.novell
Subject: HyperCard Stacks on MacVap v1.1
Message-ID: <NOVELL%90011619240566@SUVM.BITNET>
Date: 16 Jan 90 21:31:00 GMT
Sender: Novell LAN Interest Group <NOVELL@SUVM>
Reply-To: Novell LAN Interest Group <NOVELL@SUVM>
Lines: 23
Approved: NETNEWS@PSUVM Gateway
Original_To:  BITNET%"NOVELL@SUVM"


        Previously on a AppleShare network, I was able to allow more than
one user access to a HyperCard stack by giving Read-Only access to the
stack folder. While attempting to duplicate the exact environment on
MacVap v1.1 (Advanced Network v2.15 rev "C"), I receive the message

        "Can't Open Stack "stack name". File is lock or in use."

        The Netware for Macintosh Supervisor supplement says that not
Macintosh access rights correspond completely with Netware access rights.
Trustee assignments to the stack folder are [RO S]. File flags are
Read-Only [Locked] and Sharable (multi-user). These are set via Netware desk
accessory and Netware Control Center.

        I've tried various access rights but still receive the same message.
Is there a file attribute being overlooked or does MACVAP not capable of
supporting Multi-user HyperCard Stacks?

        Any assistance is appreciated. Thanks in advanced

Allan Hull
HULL@CRCVMS.UNL.EDU
(402) 472-5225