Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!THUMPER.CC.WAYNE.EDU!brian
From: brian@THUMPER.CC.WAYNE.EDU (Brian_Holmes)
Newsgroups: comp.protocols.tcp-ip.ibmpc
Subject: KA9Q and RIP
Message-ID: <88@thumper.cc.wayne.edu>
Date: 10 Jan 90 18:56:05 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Reply-To: bholmes@cms.cc.wayne.edu
Organization: The Internet
Lines: 8

I just set up an IBM AT to act as a router using KA9Q.
This works much better then the IBM routing software
for PC's.  KA9Q allows me to set a default route, while
IBM program had to have every host in a table.
I noticed the NOS version of KA9Q has a 'rip' command.
Do anyone have any docs explaining this?  I grabbed
USERMAN.DOC from flash.bellcore.com, but this didn't have
any reference to this command.