Path: utzoo!attcan!uunet!clyde.concordia.ca!mcgill-vision!bloom-beacon!snorkelwacker!think!samsung!cs.utexas.edu!sun-barr!ames!haven!decuac!shlump.nac.dec.com!shodha.dec.com!elvira!ridder
From: ridder@elvira.enet.dec.com (Hans Ridder)
Newsgroups: comp.sys.amiga
Subject: Re: A success story: CSA 68020 board and Starboard II on A1000
Message-ID: <600@shodha.dec.com>
Date: 12 Jan 90 21:49:46 GMT
References: <1212@ursa-major.SPDCC.COM>
Sender: news@shodha.dec.com
Organization: Digital Equipment Corporation, Customer Support Center
Lines: 21

In article <1212@ursa-major.SPDCC.COM> denbeste@ursa-major.spdcc.COM (Steven Den Beste) writes:
>To get it to work at all, I had to do the "PAL Grounding Mod". [At this time
>I'd like to say something: If there is an A1000 still in existence which
>hasn't had this fix done, its owner should get it done immediately.]

My A1000 is working perfectly (without the grounding mod.), you want
me to take a soldering iron to it?  Nooooo waaaaaay!  You might
actually scare some folks into doing it for no reason.  Ever heard
about sleeping dogs?

>...[Yes, I know I could probably make the part I have run at about 18
>MHZ, but I've had enough bus problems to last my life, and I don't
>want to take any more chances.]

Oh, I guess you have...

-hans
========================================================================
  Hans-Gabriel Ridder			Digital Equipment Corporation
  ridder@elvira.enet.dec.com		Customer Support Center
  ...decwrl!elvira.enet!ridder		Colorado Springs, CO